Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
1800113565_FV7XXX
7/04/08
Vertical steam ironing
Ideal for removing creases in suits, jackets, skirts, curtains, etc...
•
Hang the garment on a hanger and hold the fabric slightly taut with one hand. The
steam is very hot, so you should always do this with the garment on a hanger
– never iron clothes which someone is wearing.
•
Set the thermostat control to
MAX
•
Press the boost of steam button
from top to bottom – fig.11.
•
Set the temperature for the fabric to be ironed.
•
Set the steam control to
•
You may start ironing when the thermostat light goes out.
Spray Function
•
Whether steam or dry ironing, you are able to use the Spray button
laundry to remove stubborn creases –
Your iron is equipped with an integral anti-scale system . This system will help to provide:
•
a better ironing quality with a constant flow of steam,
•
lasting performance from your appliance.
Anti-drip function
•
If the soleplate temperature is too low, the iron will not produce steam because of
When using for the first
the anti-drip technology which prevents droplets of water leaking from the
time, wait until the light
soleplate.
goes out before
obtaining steam.
•
In order to obtain steam again, put your iron back on its base.
Maintenance and cleaning
Cleaning the anti-scale valve
•
Put the switch into the Cordless position
base
•
Empty the water compartment and place the steam control on
•
To remove the anti-scale valve, pull it up –
•
Soak the valve in a cup of white spirit vinegar or plain lemon juice for a few hours
–
fig.15.
•
Rinse the valve under running water.
•
Replace the anti-scale valve.
•
Put the switch into the Cordless position
The self-cleaning
base
function helps to slow
•
Set the steam control to
down scaling in your
•
Place your iron on its heel, set the thermostat button to
iron.
indicator light to go out – fig.9.
In order to extend the
•
Take the iron from its base and place the iron horizontally over a sink.
life of your iron, use the
•
Remove the anti-scale valve – fig.13.
Self-Cleaning function
•
Shake the iron gently, over the sink, until some of the water in the water tank (with
once a month.
the impurities) has flowed out through the soleplate – fig.15.
•
At the end of the operation, push the anti-scale valve back into position.
Cleaning the soleplate
•
While the soleplate is still slightly warm, clean it by wiping over it with a damp non-
metallic cloth.
6
17:11
Page 6
– fig.8.
button repeatedly –
fig.4
moving the iron
DRY
–
fig.6.
to dampen
fig.12.
Integral anti-scale system
(once a month)
–
fig.5
and remove the iron from its
DRY
.
fig.13.
–
fig.5
DRY
–
fig.6
and fill the water tank to MAX.
Hold the iron a few
centimetres from the
fabric to avoid burning
delicate fabrics.
Every fifth time you
press the button,
return the iron to the
horizontal position.
Dry ironing
Make sure that there
is water in the tank
before using this
button.
Be careful !
Unplug your iron and
let it cool down before
cleaning it.
- Never touch the end
of the valve.
- The iron will not
function without the
anti-scale valve.
Self-cleaning
and remove the iron from its
MAX
and wait for the
Never use abrasive or
aggressive products on
the soleplate.
Publicité
Table des Matières
