Filling The Water Tank - TEFAL FV7010 Mode D'emploi

All manuals and user guides at all-guides.com
1800113565_FV7XXX 7/04/08
• During the first few uses, a harmless odour and smoke may be given off. This has
no effect on the use of the iron and will disappear quickly.
• Your appliance has been designed to operate using untreated tap water. However,
If your water is very
hard, it is possible to mix it is necessary to operate the Self-Clean function regularly in order to eliminate hard
tap water with store-
water deposits from the steam chamber.
bought distilled or
• Heat concentrates the elements contained in water during evaporation.The types of
demineralised water in
water listed below contain organic waste or mineral elements that can cause
the following
spitting, brown staining, or premature wear of the appliance: water from clothes
proportions:
dryers, scented or softened water, water from refrigerators, batteries or air
- 50% tap water,
conditioners, boiled filtered or bottled mineral water, pure distilled or demineralised
- 50% distilled or
water or rain water should not be used in your Tefal iron.
demineralised water.

Filling the water tank

• Put the switch into the Cordless position
its base.
• Set the steam control to DRY
• Place the iron flat and fill it – fig.7.
• Put the iron back on its base.
Use
Adjust the temperature and the steam
• Select the temperature (see table below or iron's heel) setting the thermostat facing
the indicator – fig.8.
• The thermostat light comes on –
enough.
• Set the steam control – fig.10 to the desired position, consulting the table below.
FABRIC
LINEN
COTTON
WOOL
SILK
SYNTHETIC
(Polyester,Acetate, Acrylic, Nylon)
RECOMMENDATIONS
• Your iron heats up quickly: so begin by ironing fabrics that are ironed at low
temperatures first, then go on to those requiring a higher temperature.
• If you turn down the thermostat, wait until the thermostat light comes back on
before beginning to iron again.
• When ironing fabrics with mixed fibres, set the ironing temperature for the most
delicate fibre.
• For delicate fabrics we recommend testing the fabric first on an inconspicious place
eg (inside the hem).
For optimum
Use this ironing mode for small garments and fabrics that are easy to iron.
efficiency, always put
• Put the switch into the Cordless position
your iron back on its
as the thermostat indicator light goes off.
base.
Go back into Corded mode
Use this ironing mode for thick fabrics that are difficult to iron or in cases where you find yourself often using the
boost of steam button – fig.4.
• Put the switch into the Corded position.
as the thermostat indicator light goes off.
If you have to use the
boost of steam button
frequently, use the
• Wait a few seconds between each shot before pressing the boost of steam button
iron in the Corded
again.
position.
17:11 Page 5
What water to use ?
– fig.5 and remove the iron from
– fig.6.
fig.9. It will go out when the soleplate is hot
POSITION OF
THERMOSTAT CURSOR
MAX
•••
••
•
Go back into Cordless mode
– fig.5. You can start to iron as soon
– fig.1. You can start to iron as soon
Obtain more steam
•
Press the boost of steam button
GB
Attention: Always
remove your iron from
the base before filling it
up.Fill the tank up to
the"MAX".
Never fill the appliance
by holding it directly
under the tap.
STEAM SETTING
POSITION
= STEAM ZONE
In order to avoid water
dripping from the iron
onto the linen:
- Turn off the steam
when ironing silk or
synthetic fabrics.
- Set it at the minimum
position for wool.
–
from time to time fig.4.
5