Filling The Boiler; Starting The Generator; Steam Ironing - TEFAL Pressing Compact GV5010E0 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
Description
1.
Steam control button
2.
Iron temperature adjustment dial
3.
Temperature setting mark
4.
Thermostat light
5.
Iron rest
6.
Boiler cap
7.
Boiler (inside the base-unit)
Preparation
What water to use ?
• Tap water :
Your appliance has been designed to function using untreated tap water. If your water is very hard,
we recommend you use a mix of 50% untreated tap water and 50% distilled water available in
most shops.
• Types of water not to use :
Heat concentrates the elements contained in water during evaporation. The types of water listed
below may contain organic waste, mineral or chemical elements that can cause spitting, brown
staining or premature wear of the appliance: water from clothes dryers, scented or softened water,
water from refrigerators, batteries, air conditioners, rain water, boiled, filtered or bottled water.
These types of water should not be used in your TEFAL iron. Also only use distilled water as advised
above.
• Always remember :
Never use rainwater or water containing additives (like starch, fragrance or water from domestic
appliances). Such additives can affect the steam properties and at high temperature, form deposits
in the steam generator chamber which are likely to stain your washing.
If this occurs, remove the
excess water.
•Using a water jug, fill with maximum 1 litre of water untreated tap . Fill the boiler, taking care that the
water does not spill over fig.1.
•Replace the boiler cap, screwing on firmly, but not over tight.

Starting the generator

• Unwind the electric cord completely and take the steam cord out
of its housing.
• Plug your generator into an earthed socket.
• Press the on/off luminous switch. It comes on and the boiler heats
up.
• After approximately 6 minutes the steam is ready.
• When the iron is in use, the iron thermostat light on the iron comes on and goes off according to
the soleplate temperature requirement
Use

Steam ironing

• Place the iron's temperature control dial according to the type of fa-
bric to be ironed (see table below).
• The thermostat light comes on.
• To obtain steam, press on the steam control button on the iron handle
-
fig.2.
•Place your steam generator on a flat, stable, heat-resistant surface.
•Check that your appliance is unplugged and cold.
•Unscrew the boiler cap.
8.
Steam cord storage space
9.
Steam cord
10. Electric cord tidy
11. Power cord
12. Illuminated on/off switch
The first time the appliance is
used, there may be some fumes
and smell but this is not harmful.
They will not affect use and will
disappear rapidly.
11

Filling the boiler

FR
EN
DE
NL
EL
IT
ES
PT
DA
SV
NO
FI

Publicité

Table des Matières
loading

Table des Matières