Additional Functions; Anti-Drip Function; Cleaning And Maintenance - TEFAL ULTIMATE STEAM POWER FV9604 Mode D'emploi

1800128785_01_FV96XXM0G0_110x154 15/04/13 17:19 Page15
to the most delicate fibre.
• If you put your thermostat in the "MIN" position, the iron does not become hot.
Check that there is
water in the tank before
using the spray trigger.
Obtaining more steam
• Set the thermostat control to "MAX" or "
• Press the turbo steam button from time to time –
• To avoid water dripping onto your clothes, wait a few seconds before pressing again.
Hold the iron a few
centimetres from the
fabric so as not to burn
delicate fabrics.
Dry Iron function
• Adjust the temperature to the fabric being ironed.
• Set the steam control to
• You can iron when the light goes out.

Additional functions

Gliss/Glide Protect
• Your iron is equipped with a catalytic self-cleaning soleplate.
• Its exclusive coating eliminates impurities generated during normal use.
• It is recommended that you always rest your iron on its support base to preserve its self-cleaning coating.
In normal use, the auto-
stop light is on!

Anti-drip function

• The automatic steam selection function is based on the fabric being ironed, which is integrated into your iron,
reduces the steam flow at low temperatures and prevents the iron from dripping onto your clothes.

Cleaning and maintenance

Warning!
- Never touch the end of
the valve – fig.13.
- The iron does not work
without the anti-calc
valve.
All manuals and user guides at all-guides.com
Using the water spray trigger
• When ironing with the steam or dry function, press the spray trigger several times
in succession to remove stubborn wrinkles –
•••
".
fig.7.
Smoothing garments vertically
• Hang the garment on a hanger and hold the fabric using one hand. The steam
is very hot so you should always do this with the garment on a hanger – never
while someone is wearing it.
• Set the thermostat control to "MAX" –
• Pulse the turbo steam button
– fig.1.
autoclean soleplate
TM
Auto-stop safety function
• The electronic system cuts the power and the auto-stop light flashes if the iron
is placed on its support base for more than 8 minutes or left flat for more than
fig.10.
30 seconds –
• To restart the iron, simply shake it gently until the light stops flashing.
Clean the anti-calc valve
• Unplug your iron and empty the tank.
• Put the steam button on max and set the thermostat to the "MIN" position.
• To remove the anti-calc valve, press the self-clean extraction button –
pull the valve upwards – fig.12.
• Let the valve soak for 4 hours in a glass of commercially available white vinegar
or natural lemon juice – fig.14.
• Rinse the valve under tap water.
• Reposition the anti-calc valve; push it until it clicks –
15
fig.6.
fig.8.
– fig.7 and move from top to bottom – fig.9.
(depending on model)
(depending on model)
(once a month)
fig.16.
EN
(spray)
FR
PT
EL
TH
KO
HK
fig.11 and
FA
AR