Entering Programming Mode; Programming Buttons - CAME bpt MTMA/01 Manuel De Programmation

D
PROG
PROG
E
PROG
F
PROGRAMMING ENTRY PANELS WITH VA/01 OR A/01
Programming for the first time
PROG PROG
>3''
A
A
a
B
2 P.E. 2 EPs
D
1 P.E. 1 EP
E
To enable the intercommunicating function, press the intercommunicating call button you
want to call on the internal receiver you want to program E. A beep indicates that the
function has been programmed successfully. Repeat for all internal receivers to be in-
cluded in the intercommunicating group. To conclude the programming, press the PROG
button on the entry panel briefly F.
NOTE. Once an internal receiver has been included in a group by assigning the in-
tercommunicating call button, it cannot be excluded from this group. If you want to
change the call button on an internal receiver which has already been programmed
as an intercommunicating receiver, or you want to add new internal receivers to
the group, repeat the operations detailed under "programming an intercommuni-
cating group".
<1''

Entering programming mode

Press the PROG button on the power supply A until the PROG LED lights up.
The LEDs
grammed B.
M1
a
PROG
PROG
2 EPs 2 P.E. 2 EPs 2 P.E.
2 EPs 2 P.E.
and and the button LEDs flash to show the buttons are being pro-
1 P.E. 1 EP
C

Programming buttons

Press the first call button on each unit C D (see "call number"
section) until the blue LED
NOTE. The LED lights on the unit remain on to show that the
buttons have been programmed correctly.
NOTE. For the basic unit (no call buttons), you do not need to
press the buttons that are shown as flashing in figure B a.
Repeat for all entry panels to be programmed. Once programming
is complete, the configuration is implemented E and you are au-
tomatically taken to "programming calls".
1 P.E. 1 EP 1 P.E. 1 EP
and the button LEDs stop flashing.