CAME bpt MTMA/01 Manuel De Programmation page 14

F
a
G
NOTE. The operation can only be carried out from the entry panel with the blue LED
entry panel from which calls are programmed, press one of the call buttons on the entry panel you wish to use for program-
ming.
NOTE. You can force the switch from one programming mode to another by pressing the PROG button on the power supply unit
for 3 seconds and releasing within 6 seconds. If you force the switch to call programming from button programming, the button
units which have not been programmed are configured to 8 calls. If the base unit is not programmed, calls are not configured.
<1''
A
H
a
I
J
0
100 °
6
82 °
1÷9
4
72 °
54 °
K
8
b
PROG PROG
M1
b
Programming the entry panel video camera
While programming the calls, the "visual range" of the video camera can be adjusted from
any receiver. To do this, lift the handset (where present) and press the "self-connection"
button J. Starting from the default configuration, scroll through the subsequent con-
figurations K by pressing the AUX1 button, or go back to the previous configurations by
pressing the AUX2 button L. Settings are saved automatically.
2
7
5
1
9
L
3
Programming calls
The green LED
present) and press the door lock release
tons F. On the entry panel, press the call button to be linked to
the internal receiver G a. A beep confirms that the setting has
been stored G b. End the call and repeat for the other internal
receivers.
Exiting Programming
Press the PROG button briefly H. The LEDs on the entry panel
switch off.
Adjusting the brightness and colour of the unit back-
light
During call programming I a, you can control the brightness
and colour of the unit backlight. Press the left call button to select
white I b, and the right call button to select blue I c.
c
Press the same button repeatedly to select one of the five bright-
ness levels (off, 25%, 50%, 75%, 100%).
flashes. Lift the internal receiver handset (if
off (1 entry panel in F). To change the
a
M
and AUX2 but-
b