Initial Check Before Start; Glue Granulate Filling; Inserting Edgeband In Edgeband Feed; Adjusting The Height Of The Edge Band - HOLZMANN MASCHINEN KAM 535 Mode D'emploi

15 OPERATION

15.1 Initial check before start

15.1.1

Glue granulate filling

15.1.2

Inserting edgeband in edgeband feed

15.1.3

Adjusting the height of the edge band

HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
Open the cover of the granulate
container (1) and fill in the gran-
ulate. Then close the granulate
container again. (Note: heating
elements (2) should be covered)
Place the edgeband (2) on the edge-
band support (1) and pass it through
the rollers (3), as well as the pressure
roller feed (5) and feed roller (6) up to
the crosscut blade (4).
The height adjustment must be made
in 3 positions.
For position 1 and 2:
Loosen screw (S) and move the bolt to
the desired height and then retighten
screw (S).
For position 3:
Adjust the height by means of knurled
screw S1.
Note: Optimum height adjustment =
edge band + slight height play (1-
2mm) must not jam under any circum-
stances.
OPERATION
27
KAM535