Electrical Safety; Special Safety Instructions For Panel Saws; Hazard Warnings; Transport - HOLZMANN MASCHINEN KAM 535 Mode D'emploi

12.5 Electrical Safety

 Make sure that the machine is earthed.
 Only use suitable extension cords.
 Proper plugs and sockets reduce the risk of electric shock.
 The machine may only be used in humid environments if the source of current is protected
by a residual current circuit breaker.

12.6 Special Safety Instructions for Panel Saws

 Work with gloves on rotating parts is not permitted!
 Never remove sections or other parts of the workpiece from the cutting area while the ma-
chine is running.
 Adhesive and gluing unit are strongly heated during operation, avoid any contact with hot
components/adhesive and wait for cool-down phases before maintenance work..

12.7 Hazard Warnings

Despite their intended use, certain residual risks remain. Due to the structure and construction of
the machine, hazardous situations may occur when handling the machines:
A safety instruction designed in this way indicates an imminently hazardous situation
which, if not avoided, will result in death or serious injury.
Such a safety instruction indicates a potentially hazardous situation which, if not
avoided, may result in serious injury or even death..
A safety instruction designed in this way indicates a potentially hazardous situation
which, if not avoided, may result in minor or moderate injury.
A safety notice designed in this way indicates a potentially hazardous situation which,
if not avoided, may result in property damage.
Irrespective of all safety regulations, their sound common sense and corresponding technical
suitability/training are and remain the most important safety factor in the error-free operation of
the machine. Safe working depends first and foremost on you!
13

TRANSPORT

Damaged or not sufficiently viable hoists and lifting devices can cause serious injury
or even death. Always check hoists and load lifting devices for adequate load-bearing
capacity and perfect condition, carefully fasten the loads and never keep them under
suspended loads.!
To ensure proper transport, also observe the instructions and information on the transport
packaging regarding centre of gravity, attachment points, weight, means of transport to be used
and the prescribed transport position, etc.
Transport the machine in its packaging to the installation site. To manoeuvre the machine in the
packaging, a pallet truck or forklift with appropriate lifting capacity can be used, for example. For
problem-free unloading, two to three additional helpers are required due to the high weight of the
machine or a forklift/crane with appropriate hoisting equipment and qualified personnel for opera-
tion.
HOLZMANN MASCHINEN GmbH
DANGER
WARNING
CAUTION
NOTICE
WARNING
www.holzmann-maschinen.at
TRANSPORT
24
KAM535