Dimplex DWF1326 Manuel Du Propriétaire page 13

Operation
changing the switch position,
press the ON button located
on the remote control (Figure
8).
This will synchronize the remote
control and the remote control
receiver.
!
NOTE: You will have only 10
seconds to perform this last step.
Failure to do so will result in these
steps needing to be followed
again.
Battery Replacement
To replace the battery:
1. Slide battery cover open on
the remote control (Figure 8).
2. Install one (1) 12-Volt (A23)
battery in the battery holder.
3. Close the battery cover
Battery must be recycled
or disposed of properly.
Check with your Local
Authority or Retailer for recycling
advice in your area.
Figure 8
On
Button
Off Button
Plastic
Strip
Battery
Cover
13