Manufacturer's Warranty - Hilti PS 50 Mode D'emploi

Fault
The display shows "Temperat-
ure outside limits".
The display shows "Temperat-
ure change too high"
"Strong radio signal detected"
is shown in the display.
10 Disposal
Most of the materials from which Hilti tools or appliances are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, Hilti has already made arrangements for taking
back old tools or appliances for recycling. Ask Hilti Customer Service or your Hilti representative for further information.
For EC countries only
Do not dispose of electrical appliances together with household waste.
In observance of the European Directive on waste electrical and electronic equipment and its imple-
mentation in accordance with national law, electrical appliances that have reached the end of their life
must be collected separately and returned to an environmentally compatible recycling facility.

11 Manufacturer's warranty

Please contact your local Hilti representative if you have
questions about the warranty conditions.
12 FCC statement (for USA only)
CAUTION This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harm-
ful interference in a residential installation. This equip-
ment generates, uses, and can radiate radio-frequency
energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television recep-
All manuals and user guides at all-guides.com
Possible cause
Temperature above or below the per-
missible range.
The temperature inside the tool has
changed too quickly.
Interference caused by radio signal.
The tool switches itself off automatic-
ally.
tion, which can be determined by turning the equipment
on and off, the user is encouraged to try to correct the
interference by one or more of the following measures:
Remedy
Wait until temperature is within the
permissible range.
Switch the tool on again.
If possible, eliminate the radio signal
(e.g. WLAN, UMTS, aircraft radar,
transmitter mast or microwave
device) and switch the tool back on.
Re-orient or re-locate the receiving antenna.
Increase the distance between the equipment and
receiver.
Connect the equipment to an outlet on a circuit dif-
ferent from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV tech-
nician for assistance.
en
25