Manufacturer's Warranty - Hilti PD-I Notice D'utilisation Originale

In accordance with the European Directive on waste electrical and electronic equipment and its implemen-
tation in conformance with national law, electric tools or appliances that have reached the end of their life
must be collected separately and returned to an environmentally compatible recycling facility.
▶ Disposal of electric tools or appliances together with household waste is not permissible.
9 FCC statement / ISED statement
This product has been tested and found to comply with the limits for a class B digital device, pursuant to part
15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. These products generate, use and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause interference to radio communications.
There is no guarantee that interference will not occur in a particular installation. If this product does cause
harmful interference to radio or television reception, which can be determined by turning the product off and
on, the user is encouraged to try to correct the interference by taking the following measures:
▶ Re-orient or move the receiving antenna.
▶ Increase the distance between the product and receiver.
▶ Connect the product to a power outlet on a circuit different from that to which the receiver is connected.
▶ Consult your dealer or an experienced TV/radio technician for assistance.
Changes or modifications not expressly approved by Hilti may restrict the user's right to operate the product.
This product complies with the requirements set out in Paragraph 15 of the FCC rules and in RSS 210 of IC.
Operation of the product is subject to the following conditions:
▶ This product should cause no harmful interference.
▶ This product must accept any interference received, including interference that may cause undesired
operation.
FCC statement on RF radiation
The RF radiation of the product described is below the limits for portable devices stipulated by the FCC in
accordance with KDB 447498.
Statement on RF radiation
The radio frequencies emitted by the product described are below the limits for portable devices imposed
by Health Canada's Safety Code 6. The distance between the RF emitter and the user and/or uninvolved
third parties is less than 20 cm.
10 Additional classification data (China)
Permissible scatter of the reference measure-
ment
Repeatability
Display error
11 Compliance with the Japanese Radio Law
This product is approved in accordance with the Japanese Radio Law (電波法).
12

Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
*2222191*
Class 1, ≤ 0.04 in
(Class 1, ≤ 1 mm)
Class 1, ≤ 0.04 in
(Class 1, ≤ 1 mm)
Stage 1, ± 0.1 in + 5 × 10-5 D (D = measurement
distance)
(Stage 1, ± 3 mm + 5 × 10-5 D (D = measurement
distance))
2222191 English 13