Installment; Installment Requirements; Connecting The Appliance To The Power Supply; Filling The Water Tank - Philips COM004A Mode D'emploi

START-UP
4

INSTALLMENT

For personal safety follow the "Safety
regulations" found on pages 23-24.
4.1 Packaging
The original packaging has been designed
to protect the appliance during transportation.
You are recommended to keep it for later
use.

4.2 Installment requirements

Before installing the machine read the
following safety instructions carefully:
• Locate the machine in a safe place;
• Make sure that it is out of the reach of
children;
• Do not place the machine on a hot
surface or near a naked flame.
The machine is now ready to be connected
to the house electricity supply.
4.3 Connecting the appliance to the
power supply
Electricity can be dangerous, so
always follow
regulations carefully.
Never use a faulty cable.
Faulty plugs and cables must be
changed immediately by authorised
personnel.
The coffee maker must be connected to a
suitable wall socket. The voltage of the
appliance has been factory-set. The voltage
on the rating plate (positioned on the
bottom of the appliance) must correspond
to that of your house electricity supply.
Com004a 165925900 Rev01.pmd
• Uncoil a length of cable from the cable
wind found underneath the appliance,
sufficient for the plug to reach the wall
socket.
• Check that the main switch is in the "0"
position before inserting the plug in the
wall socket.
• Plug the appliance into a wall socket
carrying the correct voltage.

4.4 Filling the water tank

•
• Lift out the water tank (1), making sure
you do not damage any of the tubes
inside it.
•
without overfilling.
•
place, making sure that the tubes
removed previously are all immersed in
water.
water inflow valve.
This valve closes automatically when the
the safety
tank is removed to prevent water
leakage.
When putting the tank back, press
lightly on it to open the valve.
• Put the lid back on the tank.
other liquids may damage the tank.
there is enough water in the tank.
25
Remove the water tank lid (2).
Rinse and fill the tank with fresh water
Put the water tank back in its right
Warning! The tanks of some
models are equipped with a
Always fill the tank with fresh, not
carbonised water: hot water or
Do not use the coffee maker
without water, always check that
13/07/2003, 18.30
25