Orbegozo PHF 50 Manuel D'instructions page 16

PHF 50
Different angles of installation.
FUNCTION
1. Plug heater to mains, ensure mains connection is the correct one for appliance.
2. Push ON/OFF button on right side of heater.
3. Turn on heater pressing ON/OFF button with remote control, to turn off press same button.
4. Set desire power with buttons: I (1000W) or II (2000W).
CLEANING AND MAINTENANCE
It is recommended a regular cleaning to keep heater in good conditions and so extend his useful life. To
clean it follows below steps:
Unplug the appliance from mains before clean it.
1. Ensure appliance has cooled down before cleaning.
2. To keep heater clean, outer housing can be cleaned with a soft, damp cloth. You can use mild detergent
if necessary. After cleaning, dry heater with a soft cloth. (CAUTION: do not let liquids enter the heater).
3. Do not use alcohol, gasoline, abrasive powders, furniture polish or rough brushes to clean the heater.
This may cause damage or deterioration to surface of heater.
4. Do not immerse heater in water.
16