Step 6 - Secure The Drain Hose; Step 7 - Connect The Water Hose - Haier HLP21N Guide De L'utilisateur

Masquer les pouces Voir aussi pour HLP21N:
Table des Matières

Publicité

CASTERS
Using the caster wrench turn the locking nut on the caster clockwise or
counterclockwise to adjust the height.
Raise

STEP 6 - SECURE THE DRAIN HOSE

1. Put the drain hose hook end in a drain pipe or laundry tub.
2. Secure the drain hose in place by fastening it to a water hose, the standpipe, or a
leg on the laundry tub. See "Drain System Requirements" for details.

STEP 7 - CONNECT THE WATER HOSE

IMPORTANT: Only use a new hose when installing the washer.
NOTE: Periodically inspect hose for cracks, cuts, leaks or wear. Replace with new
hose every 5 years.
1. Check that a flat washer is present and firmly in place in each end of the water
inlet hose. Flat washers are pre-installed at the factory.
Lower
Locking Nut
A
Washer
13

Publicité

Chapitres

Table des Matières
loading

Table des Matières