Makita AF505N Manuel D'instruction page 8

Maintenance of nailer
Always check the tool for its overall condition and loose
screws before operation. Tighten as required.
With tool disconnected, make daily inspection to assure
free movement of the contact element and trigger. Do
not use tool if the contact element or trigger sticks or
binds.
When the tool is not to be used for an extended period
of time, lubricate the tool using pneumatic tool oil and
store the tool in a safe place. Avoid exposure to direct
sunlight and/or humid or hot environment.
Maintenance of compressor, air set
and air hose
1
► 1. Drain cock
1
► 1. Air filter
After operation, always drain the compressor tank and
the air filter. If moisture is allowed to enter the tool,
It may result in poor performance and possible tool
failure.
Check regularly to see if there is sufficient pneumatic
oil in the oiler of the air set. Failure to maintain sufficient
lubrication will cause O-rings to wear quickly.
8 ENGLISH