Important - Sanus VML5 Manuel D'instructions

4. Place the wall plate template
template and tape in place.
10
NOTE: For assistance in determining wall plate location, see HeightFinder at sanus.com.

IMPORTANT

: Be sure you mark and drill into the center of the stud.
5. Drill the middle two pilot holes (into the stud) using a 7/32 in. (5.5 mm) diameter drill bit.
IMPORTANT
: Pilot holes must be drilled to a depth of 3 in. (75 mm).
4
12
at your desired height and position the middle holes over your stud center lines. Level the wall plate
10
10
5
3 in. (75 mm)
7/32 in.
(5.5 mm)
10
15