Table des Matières
Publicité
4.
Place the wall plate template
template
and tape in place.
10
NOTE: For assistance in determining wall plate location, see HeightFinder at sanus.com.
IMPORTANT
: Be sure you mark and drill into the center of the stud.
5.
Drill the four pilot holes using a 7/32 in. (5.5 mm) diameter drill bit.
IMPORTANT
: Pilot holes must be drilled to a depth of 3 in. (75 mm).
4
at your desired height and position the slotted holes over your stud center lines. Level the wall plate
10
12
10
5
3 in. (75 mm)
7/32 in.
(5.5 mm)
10
11
Publicité
Table des Matières
