Setting-Up Operation; Using The Radio-Controlled Socket - SilverCrest RC DP3 4001-A FR 3726 Instructions D'utilisation Et Consignes De Sécurité

Setting up / Setting-up operation
5. Repeat this process with the other
wireless sockets.
Note: You can use one channel
ON/OFF button
several remote-controlled sockets
at once. You can further train six
remote controls successively and
use these for a single receiver. This
means you can switch one appli-
ance on and off from up to six
different places. In this case, syn-
chronise every remote-controlled
socket with the channel of the
remote control.
Note: The codes for the remote
control will also remain stored
when changing the batteries.
Note: The codes will remain per-
manently stored when disconnect-
ing the remote-controlled socket
from the power supply.
Note: Avoid interference: Ensure
the various remote-controlled
sockets are approx. 50 cm apart.
Note: The LED operating status dis-
play indicates if the remote-con-
5
trolled socket is in ON/OFF mode.
Deleting a code:
To delete a code, first repeat steps
1 – 3.
With the LED operating display
flashing, press the desired OFF
button of the channel ON/ OFF
button (A, B, C or D) you wish
2
to delete on the remote control.
The LED operating status display
will flash rapidly for approx. 2 sec-
onds to confirm deletion.
32 GB
284705_silv_Funksteckdosen-Set_IP20_Content_FR.indd 32
to switch Deleting all codes:
2
Q
Q
5
5
It will then flash slowly again for
approx. 30 seconds and a new
code entered.
To delete all codes, first repeats
steps 1 – 3.
Then with the LED operating status
display flashing, press the
5
ALL-OFF button on the remote
3
control. The LED operating status
display will flash rapidly for
5
approx. 2 seconds to confirm dele-
tion, then go out.

Setting-up operation

Using the radio-controlled
socket (fig. B)
1. Put the radio-controlled socket into
any shuttered socket and connect
the appliance you want to operate.
2. Switch the electrical appliance on.
The radio-controlled socket can
only perform its switching function
when the device to be controlled is
switched on.
ATTENTION! FIRE HAZARD!
Do not attach any appliances which
could cause fires or other damaged
if left unattended when switched
on. The maximum load of every
radio-controlled socket is approx.
3,680 W. Any overload could cause
a risk of fire or damage to the device.
21.06.17 15:34