dorma MUTO COMFORT L 80 Notice De Pose page 4

MUTO COMFORT L 80 / XL 150
—
ORIGINAL INSTRUCTIONS
READ CAREFULLY BEFORE USE
KEEP SAFE FOR
FUTURE REFERENCE
About these instructions
These instructions are for installation of the MUTO sliding door
XL 150
system L 80 and for the following mounting and
style versions:
Wall mounting
Ceiling mounting
Version on glass wall
additional steps for wall installation
(p. 24)
Version with side panel
additional steps for ceiling installation
(p. 26)
Version with wood panel door
additional installation steps (p. 30)
These instructions describe the installation of a left hand door.
Use mirror image for a right hand door.
Two-leaf sliding door
deviating installation steps
Target group
Installation by DORMA authorized professionals only.
Intended use
- for sliding doors in dry indoor areas only
- for manual slow opening and closing only, door leaf
must be stopped manually before reaching end position
Wall/Ceiling requirements and fittings
- The substructure/wall must be able to bear permanent loads,
be level and perpendicular (max. tolerance: 2 mm per meter).
- Fittings must be sufficiently dimensioned for the substructure/
wall and for the weight of the door. Please read the technical
information for fittings.
- Fittings are not included.
Requirements for glass panel:
- Heat-soaked thermally toughened safety glass
(ESG-H in compliance with DIN EN 12150-1)
- Clamping area must be level and uncoated
(no self-cleaning coating!)
4 DORMA
Safety instructions
- Installation requires two people
- Always wear protective clothing
Symbols used – Safety
Caution!
Fittings must meet the requirements of
substructure/wall and door weight
Risk of breaking glass
When fitting the door, support the panel with
a block of wood or similar object.
Risk of crushing!
Position buffer stop so door handles (optional)
are at least 25 mm away from the wall.
Always use silicone- and oil-free cleaners
(e.g. acetone).
Symbols used – Installation
Read notes
Reference to deviating installation steps
A
A
(Example here: wood panel, step A)
1 2
Installation sequence
A B
Successive installation steps for different versions
Individual steps within an installation step
1 2
Closing edge
Maintenance, care, repair
- minimum of 5 years maintenance-free operation
(based on 50 cycles per day)
- immediately replace damaged parts
- always use original DORMA parts
- use a damp cloth for occasional cleaning especially
of the track
Disposal
Dispose in accordance with national regulations.
EN