Pipeline Connection - hajdu Z30E Instructions De Montage Et D'utilisation

same plane, then you should tighten
the screw again.
4. Mount the hot water tank on the
wall according
instructions.
In order to install the hot water
tank, the following conditions should
be ensured:
-Horizontal flat flooring, to guarantee
absolutely vertical standing of the unit.
Vertical standing should be performed
with adequately secure support of the
legs.
-The unit should be installed in a way
that its distance from the wall is at
least 50 mm.
-In order to ensure removal of the
closing cover and cleaning the interior
of the tank, a distance of at least 70
cm should be guaranteed between the
fitting house (the front surface of the
unit) and the wall or other structural
building elements.
-Adequate electricity, pipeline and
waste water collection systems should
be ensured on the location of the
installation.
-In order to reduce heat loss due to hot
water pipe, it is highly recommended
that you install the unit close to
locations using hot water. In case of
larger distance between the unit and
the location using hot water, is it
reasonable to provide insulation for the
hot water pipe.

4. PIPELINE CONNECTION

Any steel pipe, plastic pipe and red
copper pipe or flexible pipe connection
adequate to a water pressure rated as
0.6 MPa can be used as hot or cold
water pipes.
All manuals and user guides at all-guides.com
to the above
EN
In case of connecting red copper
pipes to the pipeline system, the use
of insulating intermediate pieces is
compulsory.
One of the intermediate pieces has
to be mounted directly to the hot
water pipe of the water tank, while
another intermediate piece has to
be mounted between the already
fixed fittings and the red copper
pipeline system.
connection
pieces, our Company undertakes no
guarantee
corrosion of internally threaded pipe
ends of the water tank, neither any
liability resulting from or related to
such events. The middle piece not
accessory. Can be ordered:
Article Nr.
Article Nr.1252122514
The water tank should be connected
to the pipeline system according to
Figure 2.
IT IS AT THE RISK OF DEATH AND
THEREFORE IT IS FORBIDDEN TO
PUT THE WATER TANK UNDER A
PRESSURE
PERMITTED OPERATION PRESSURE!
4.1 The combined safety valve is an
accessory of the water tank.
connection to the hot water tank
and to the
, Rp1/2

threaded.
The valve
DIRECTLY in front of the water tank
into the cold water pipe, respecting
the flow direction marked by an
13
In case
without intermediate
for defects due
1252122513,
LARGER THAN
pipeline system:
; Rp3/4 internally
has to be mounted
of
to
3/4"
1/2"
THE
Its