Maintenance; Lubrication; Brush Replacement; General Maintenance - Ryobi D700W Manuel D'utilisation

WARNING:
When servicing, use only identical replacement parts.
Use of any other parts can create a hazard or cause
product damage.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which could result in serious personal
injury.
NOTE: FIGURES (ILLUSTRATIONS) START ON PAGE 11 AFTER
All manuals and user guides at all-guides.com

MAINTENANCE

FRENCH AND SPANISH LANGUAGE SECTIONS.

LUbRICATION

All of the bearings in this tool are lubricated with a sufficient
amount of high grade lubricant for the life of the unit under
normal operating conditions. Therefore, no further lubrica-
tion is required.

bRUSH REPLACEMENT

See Figure 5, page 11.
The impact wrench has externally accessible brush assem-
blies that should be periodically checked for wear.
 Unplug the impact wrench.
 With a flat head screwdriver, remove the brush caps. The
brush assembly is spring loaded and will pop out when
you remove the brush cap.
 Remove the brush assembly (brush and spring). Check
for wear. If worn, always replace in pairs. Do not replace
one side without replacing the other.
 Replace the brush assembly.
 Replace the brush cover and tighten with a screwdriver.
Do not overtighten.
9 − English