Electrical Requirements - KitchenAid 5KSM7990X Manuel D'utilisation Et D'entretien

Masquer les pouces Voir aussi pour 5KSM7990X:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 31
PRODUCT SAFETY
10. If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent, or similarly qualified persons in order to avoid a hazard.
11. Never leave the appliance unattended while it is in operation.
12. Do not use the Stand Mixer outdoors.
13. Do not let the cord hang over the edge of table or counter.
14. To avoid product damage, do not use the Stand Mixer bowls in areas of high
heat such as an oven, microwave, or on a stovetop.
15. Remove the Flat Beater, Wire Whip, or Spiral Dough Hook from the Stand Mixer
before washing.
16. Refer to the "Care and Cleaning" section for instructions on cleaning the
surfaces in contact with food.
17. The appliance is not to be cleaned with a water jet.
18. This appliance is intended to be used for commercial applications, for example in
kitchens of restaurants, canteens, hospitals and in commercial enterprises such
as bakeries, butcheries, etc., but not for continuous mass production of food.
SAVE THESE INSTRUCTIONS

ELECTRICAL REQUIREMENTS

Electrical Shock Hazard
Plug into an earthed outlet.
Do not remove earth prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these
instructions can result in
death, fire, or electrical shock.
The acoustic pressure level measured in conformity with the prEN 454-test code is less
than 70 dBA.
A * in the model number indicates additional characters that designate machine colour
and engineering digits for the actual model (eg. 5KSM7990X).
4
W11457004A.indb 4
W11457004A.indb 4
Voltage: 220-240 V~
Frequency: 50-60 Hz
Wattage: 325 W
Recommended operating time:
1-30 minutes with a duty cycle of
10 min. ON / 15 min. OFF (0).
Do not use an extension cord. If the
power supply cord is too short, have a
qualified electrician or service technician
install an outlet near the appliance.
The wattage rating is determined by using
the attachment that draws the greatest
load (power). Other recommended
attachments may draw significantly less
power.
This product is supplied with a Y
type power cord. If the power cord is
damaged, it must be replaced by the
manufacturer or a service agent in order
to avoid a hazard.
03-09-2020 11:42:27
03-09-2020 11:42:27

Publicité

Table des Matières
loading

Table des Matières