Marquant 880-138 Mode D'emploi page 41

Unreasonably high value is
shown for systolic or diastolic
pressure
Unreasonably low value is
shown for systolic or diastolic
pressure
Guidelines and manufacturer's certificate concerning electromagnetic radiation
The blood pressure monitor is intended to be used in electromagnetic environments in accordance with
the specifications below. It is incumbent on the customer or the person using the blood pressure monitor
to ensure that the electromagnetic environment in which it is used complies with these specifications.
Emission test
Radio frequency
radiation CISPR 11
Radio frequency
radiation CISPR 11
Overtones IEC 61000-
3-2
Voltage fluctuation/
flicker IEC 61000-3-3
Guidelines and manufacturer's certificate concerning electromagnetic immunity
The blood pressure monitor is intended to be used in electromagnetic environments in accordance with
the specifications below. It is uncumbent on the customer or the person using the blood pressure monitor
to ensure that the electromagnetic environment in which it is used complies with these specifications.
Immunity test
Electrostatic discharge
(ESD)
IEC 61000-4-2
The sleeve was held
•
lower than the heart
The sleeve was not fitted
•
properly
• You moved or spoke
during the measurement
• The sleeve was held
higher than the heart
• You moved or spoke
during the measurement
Compliance Guidelines for electromagnetic environment
Group 1 Radio frequency energy is only used in the blood pressure
monitor for the internal functions in the product. The emitted
radio frequency radiation is therefore very low and the
probability of it causing interference in nearby electronic
equipment is low.
Class B The blood pressure monitor is suitable for use in apartments
and similar environments, directly connected to low voltage
networks for the distribution of electricity to apartment
Not applicable
buildings.
Not applicable
Test level as per Compliance level
IEC 60601
±6 kV on contact ±6 kV on contact
±8 kV over air gap ±8 kV over air gap
ENGLISH
•
Guidelines for electromagnetic
environment
The floor surface should consist of
wood, concrete or clinker. In rooms
with floors covered with synthetic
material the relative air humidity
should be at least 30%.
41
Stay in the correct posture and
measure again.