Changing Volume Lock; Locking Volume Control To One Mode (Global Volume Lock); Unlocking Volume Control For A Single Device (Individual Volume Unlock); Unlocking All Volume Control (Restoring Default Setting) - One for All Kameleon URC-6692 Guide D'utilisation

OFA Kam 6 Hybrid Owners Manual Fr-Eng.fm Page 16 Monday, April 11, 2005 12:45 PM
OFA Kameleon™ 6-Device Hybrid Remote
2. Press and hold SET until the two Inner
IR segments flash twice. The current
mode key will blink on and off during
programming.
3. Enter 9 9 4. The Inner IR Segments
will blink twice.
4. Press the destination key twice (where
the keymoved key is stored). The Inner
IR Segments will blink twice.
Restoring All Keymoved Keys In A Single
Mode
1. Press and hold SET until the two Inner
IR segments flash twice. The current
mode key will blink on and off during
programming.
2. Enter 9 9 4. The Inner IR Segments
will blink twice.
3. Press the destination mode twice
(where keymoved keys are stored).
The Inner IR segments flash twice.

CHANGING VOLUME LOCK

The OFA Kameleon™ 6-Device Hybrid
Remote (URC-6692) is set at the factory for
independent volume control of each
selected device. However, you may change
the Volume Lock setting to Global Volume
Lock so that a device's volume will be
locked to one mode (e.g., to control TV
volume in all other modes). After that, if
desired, you can perform Individual
Volume Unlock on a selected device to set
its volume control for independent
operation.
L V C
OCKING OLUME ONTROL
(G V L ):
LOBAL OLUME OCK
Press and hold SET until the two Inner
1.
IR segments flash twice. The current
mode key will blink on and off during
programming.
16 Changing Volume Lock
2. Enter 9 9 3 and then press any mode
key once (e.g., TV). The Inner IR
Segments will blink twice.
Now, when you press VOL+, VOL-, or MUTE,
the volume of the selected device (e.g., TV)
will be controlled regardless of the mode
you have selected.
U
NLOCKING
S D
INGLE EVICE
U ):
NLOCK
1. Press a desired mode key where you
want volume to be unlocked (e.g., AUD)
and controlled within its own mode.
2. Press and hold SET until the two Inner
IR segments flash twice. The current
mode key will blink on and off during
programming.
3. Enter 9 9 3 and then press VOL- once.
The Inner IR Segments will blink four
times.
4. If desired, repeat steps 1 through 3 (of
this section) for each device that you
want volume to be unlocked.
Now, after you select a device that has
volume unlocked (e.g., AUD), pressing
VOL+, VOL-, or MUTE, will control the
device's volume only in its own mode.
U
NLOCKING
(R
ESTORING
NOTE: Performing these instructions will
restore independent volume control for all
programmed devices (e.g., TV volume
control in TV mode, VCR volume in VCR
T O M mode, etc.).
O NE ODE
1. On the remote control, press and hold
SET until the two Inner IR segments
flash twice. The current mode key will
blink on and off during programming.
V C F A
OLUME ONTROL OR
(I V
NDIVIDUAL OLUME
A V C
LL OLUME ONTROL
D S ):
EFAULT ETTING