Stryker IsoTour Pump Mode D'emploi page 16

A A c c t t i i v v a a t t i i n n g g C C P P R R r r e e l l e e a a s s e e
Remove the hose from the pump to deflate the support surface for CPR. Follow your hospital protocol for CPR.
P P o o w w e e r r i i n n g g o o n n o o r r o o f f f f L L o o w w A A i i r r L L o o s s s s ( ( L L A A L L ) )
LAL is on by default. This function can be turned off or on.
1. Press the action button next to the active (green) LAL icon to turn off this function (Figure 7).
2. Press the action button next to the inactive (white) LAL icon to turn on this function (Figure 8).
S S e e l l e e c c t t i i n n g g T T r r u u T T u u r r n n
W W A A R R N N I I N N G G
• Never transfer or transport a patient while T T r r u u T T u u r r n n is in use.
• Always raise the bed siderails before you begin T T r r u u T T u u r r n n , to avoid the risk of patient fall.
• Do not leave the patient unattended until T T r r u u T T u u r r n n of the patient position is complete.
1. Make sure you read the I I s s o o T T o o u u r r support surface operations manual before you start T T r r u u T T u u r r n n .
2. Press the action button next to the patient left or patient right T T r r u u T T u u r r n n (Figure 9).
EN 12
F F i i g g u u r r e e 7 7 – – L L A A L L o o n n
F F i i g g u u r r e e 8 8 – – L L A A L L o o f f f f
2874-009-001 Rev AA.0