Operating The Digital Display - Skil 3400 Consignes De Fonctionnement/Sécurité

SM 2610947705 7-09:SM 2610947705 11-06 7/9/09 2:13 PM Page 46
5. Have blade extend approximately 1/8" above top of workpiece.
Additional blade exposure would increase the hazard potential.
6. Do not stand directly in front of the blade in case of a
KICKBACK. Stand to either side of the blade.
7. Keep your hands clear of the blade and out of the path of the
blade.
8. If the blade stalls or stops while cutting, TURN SWITCH OFF
before attempting to free the blade.
9. Do not reach over or behind the blade to pull the workpiece
through the cut ... to support long or heavy workpieces ... to
remove small cut-off pieces of material or FOR ANY OTHER
REASON.
10. Do not pick up small pieces of cut-off material from the table.
REMOVE them by pushing them OFF the table with a long stick.
Otherwise they could be thrown back at you by the rear of the
blade.
11. Do not remove small pieces of cut-off material that may
become TRAPPED inside the blade guard while the saw is
RUNNING. THIS COULD ENDANGER YOUR HANDS or cause a
KICKBACK. Turn the saw OFF. After the blade has stopped
turning, lift the guard and remove the piece.
12. If workpiece is warped, place the CONCAVE side DOWN. This
will prevent it from rocking while it is being ripped.

Operating the Digital Display

1. To activate the Digital Display, press the ON/OFF button and
hold for 2 seconds. The display will be set to zero and the default
will be set to Fractional Inch. (Fig. 38)
2. To choose the desired mode of measurement (fractional inch,
decimal inch, mm), press the INCH/MM button. The default
measurement is fractional inch.
3. To choose the width, press the ZERO button until the desired
measurement appears.
4. To clear the Digital Display, press the ZERO button for more
than 3 seconds. The previous measurement unit will be kept.
5. To deactivate the Digital Display, press the ON/OFF button for
more than 3 seconds. The device will reset to default mode.
6. Sleep Mode: If no operation is detected after thirty minutes, the
device will enter SLEEP mode. Pressing ANY buttons or
activating the sensor will awaken the device without changing
the current measurement. The device will deactivate to OFF
mode after 3 hours in SLEEP mode.
NOTE: Digital display works best on the right hand side of the
blade.
ERROR MESSAGES
1. Err 1 (or Err L): left sensor not working (cannot read from left
sensor when right sensor is reading)
2. Err 2 (or Err R): right sensor not working (cannot read from right
sensor when left sensor is reading)
3. Err 4 (or Err): inconsistency of readings (can read from sensors
but inconsistency or not the correct sequence)
4. Err 5 (or count): maximum count reached (2000mm or
99.999inch)
ON/OFF
ENCENDIDO/ P G DO PULG D S/MM CERO
46.
FIG. 38
INCH/MM ZERO