Operation; Filling The Water Reservoir - Skil 3550 Guide D'utilisation

OPERATION

Tile Saw Location
WARNING
making any adjustments or changing
accessories. Such preventive safety measures
reduce the risk of starting the tool accidentally.
Use the tile saw in a well lit area and on a level
surface, clean and smooth enough to reduce
the risk of trips and falls. Use it where neither
the operator nor the casual observer is forced
to stand in line with the blade.
To avoid the possibility of the appliance plug or
receptacle getting wet, position tile saw to one
side of a wall mounted receptacle to prevent
water from dripping onto the receptacle or
plug. The user should arrange a "drip loop" in the cord connecting the saw to a receptacle.
The "drip loop" is that part of the cord below the level of the receptacle, or the connector if an
extension cord is used, to prevent water traveling along the cord and coming in contact with
the receptacle.
DANGER
supplies power to the tool. Then unplug and examine for presence of water in the
receptacle.

Filling the Water Reservoir

1. Open bevel table.
2. Fill the water reservoir in between the
minimum and maximum fill level; do not
over-fill. (Fig. 9)
3. Do not add chemicals or detergents to the
water.
4. Close bevel table.
To change reservoir water:
1. Unplug tile saw.
2. Empty water through overflow hole into a
bucket. Do not allow water to splash onto
ground or on machine.
3. Discard waste water in accordance with local
regulations.
CAUTION
tile blade.
18
Disconnect the plug from
the power source before
To reduce the risk of electrocution, DON'T unplug the cord if the plug
or receptacle gets wet. Disconnect the fuse or circuit breaker that
Never turn on the machine without enough water in the tray. Add
water if you notice saw dust in the air. Lack of water may damage the
Fig. 8
Power
Supply
Cord
Drip Loop
Fig. 9
Overflow Hole
Tilesaw
Tilesaw
Support
Water Reservoir