Assembly - Klarstein STUDIO LIGHT & FIRE 1 Mode D'emploi

EN
28

ASSEMBLY

WARNING
Risk of electric shock and other injuries! Only assemble the dos device
as described in the operating instructions.
Required tools:
2mm pilot drill bit
Drill bit (8 mm, you may need to be a masonry bit)
Phillips screwdriver
Power drill
Assembly instructions
Before you begin with the assembly, please note the following points:
• 2 persons are required for assembly.
• Keep your back straight when lifting.
• Avoid turning your hips. It is better to put your feet back on.
• Avoid strong bending of your upper body. Always go to your knees instead
of bending your hips. Do not lean in front of or to one side while carrying the
fi replace.
• Always grasp with the palm of your hand. Do not use your fi ngertips to hold the
fi replace.
• Keep the fi replace as close to the body as possible to avoid unnecessary and
disproportionate strain on the body.
• Use gloves for extra support.
• Ask for help if needed.
Unpacking the contents
The device is delivered in a single carton. When carefully removing the unit, observe the
following instructions:
• Make sure that the device is in the correct position, as it is printed on the carton.
• Remove the tapes cuffs.
• Carefully lift the fi replace out of the carton.
• Remove the transport protection and the foils from the fi replace.
Helpful advice before fi tting
The appliance can be operated either by the switches located on the left hand side of
the fi replace under its canopy or by the supplied remote control.