Worx WU621 Mode D'emploi page 10

8. EXTERNAL DUST EXTRACTION
The dust extraction (5) is best connected to a
suitable external dust extraction machine e.g.
vacuum cleaner.
9. REPLACING CARBON BRUSH
Warning: Always be sure that the
tool is switched off and unplugged
before attempting to perform inspection
or maintenance.The motor brush can be
easily accessed on either the front or
back of the motor housing.
ATTENTION:
When servicing a tool, ALWAYS use only
identical replacement parts.
STEP1: Locate the plastic motor brush caps
on both the front and back of the motor
housing.
STEP2: Remove the threaded brush cap on
accessible carbon brush (20) with a flathead
screwdriver and turn the screw in a counter-
clockwise rotation to loosen.
STEP3: Gently remove the old motor brush.
STEP4: Carefully insert the replacement
brush. Ensure the brush is completely inserted
into the holder and is seated properly and is
10
free to move inside its holder.
STEP5: Replace the brush cap with the flat-
head screwdriver, turning clockwise to tighten.
Do not apply excessive force as this may
damage the access brush caps.
WORKING HINTS FOR YOUR
PLANER
Warning: Danger of kickback! Apply
the machine to the work piece only
when switched on.
1. STANDARD SURFACE PLANING
Set the desired cutting depth. Position the
front part of the base plate flat onto the work
surface. Switch the machine on and push your
planer forward and it will start cutting, always
maintain all of the base plate flat on the work
surface to prevent the cutting blade jumping.
Move the plane evenly over the work surface.
For most applications 0-2mm max cutting
depth will produce a good surface finish. It is
best to use small depths of cut and repeat the
planing process.
Planer
13L-WU621-M-070305¸ÄFÓïCE´¦.indd 10
2. EDGE CHAMFERING
Using the V-groove in the base plate (15)
you can make a chamfer on the work piece
edge (See I). Guide the planer along the edge
and maintain a constant angle and force to
produce a good finish.You can control the
angle of the chamfer with your hands. Make a
test chamfer on a scrap piece of wood. Ensure
your work piece is clamped and supported
near the edge.
3. REBATING
You use the Rebate Depth Gauge (16) and
the Rebate Parallel Guide (17) accessories
(supplied with your tool). Fit these accessories
to your planer. Set the required rebate depth
using the scale and the mark on the planer
housing next to the scale (See J)Loosen
locking screw(21) and adjust the required
rebating width(max 82 mm). (See K)Tighten
locking screw (21) Adjust the desired rebating
depth with the rebating depth gauge (16)
accordingly (max 9mm) (See L).Plane as often
as necessary to achieve the desired rebating
depth. Make sure the plane is guided with a
lateral supporting pressure.
MAINTENANCE
Warning: Remove the plug from
the socket before carrying out any
adjustment, servicing or maintenance.
Always keep the machine and the motor
ventilation slots clean for safe and
proper working.
If the machine should happen to fail
despite regular maintenance, please call
our customer helpline for advice.
Your power tool requires no additional
lubrication or maintenance. Never use water
or chemical cleanser to clean your power
tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the
motor ventilation slots clean. Keep all working
controls free of dust. If you see some sparks
flashing in the ventilation slots, this is normal
and will not damage your power tool.
ENG
3/5/2007 4:17:14 PM