Water Level Indicator - Air-O-Swiss AOS U200 Mode D'emploi

Use of fragrances
On the outside of the main body is a fragrance container
(21). Remove the fragrance container by pushing it briefly.
Fragrances can be dribbled onto the fleece pad in the con-
tainer. A few drops are sufficient – liquid must not be present
in the container. Apply fragrances only onto the fleece pad
or a cotton-wool pad and never add directly to the contai-
ner (22)! Water additives (e.g. etheric oils, fragrances, water
purifiers) must NOT be added to the water tank or directly
into the nebulizer space! Even a small amount can damage
the plastic of these parts or create cracks. Appliances that
are damaged by additives are not covered by the warranty.
Remove the fragrance container before emp-
tying and cleaning the appliance.
Operation A) On-off switch and regulation of mist
output
Turning the rotary switch clockwise switches the appliance
on and at the same time regulates the mist output from
low to high.
B) Water level indicator
The water level indicator clearly shows how much water is
in the appliance. The appliance switches off automatically
when the water tank is empty. The water level indicator illu-
minates red. For further information please read the section
«Filling the tank». After inserting the full tank, it may take a
few seconds until the red light goes out.
C) Switching blue illumination on/off
The blue illumination can be switched on and off with the
sliding switch on the backside of the main body. The red
illumination cannot be switched off.
en
11