Connecting The Power Cord; Preparing The Remote Control; Installing Batteries In The Remote Control - Samsung DVD-R170 Manuel

getting started

Connecting the Power Cord

After all connections are complete, plug the power cord into a wall outlet.

Preparing the Remote Control

Installing batteries in the Remote Control

1. Lift the cover at the back of the
remote control upward as shown.
If the remote control does not operate properly:
•
Check the polarity +/- of the batteries.
•
Check if the batteries are drained.
•
Check if the remote sensor is blocked by obstacles.
•
Check if there is any fl uorescent lighting nearby.
Dispose of batteries according to local environmental regulations.
Do not put them in the household trash.
You can then control the television using the following buttons.
Button
TV POWER
INPUT SEL.
TV VOL +/-
CH (,.)
0~9
100+ Button
M

You can control only Samsung TV with this remote control.

The various functions may not be able to be controlled on all televisions. If you encounter problems, operate the
television directly.
14_ getting started
2. Install two AAA size batteries.
Make sure to match the "+" and "–"
ends of the batteries with the diagram
inside the compartment.
Function
Used to switch the television on and off.
Used to select an external source.
Used to adjust the volume of the television.
Used to select the desired channel.
Used to input number directly.
Used to select channels over 100.
3. Replace the cover.
Assuming typical TV usage,
the batteries last for about one
year.