SilverCrest SHSK 3.7 A1 Mode D'emploi page 87

All manuals and user guides at all-guides.com
__NAS280611_Haarschneider_kompakt_B1.book Seite 85 Montag, 7. November 2016 2:20 14
5. Charging
NOTES:
• Before the device is used for the first time, and during the fol-
lowing three charging procedures, the device should be
charged for 90 minutes in each case.
• When the batteries are nearly empty, the LED 2 flashes red.
The device can then only be used for a short time without be-
ing connected to the electricity supply.
• When the battery is fully charged, the device can be used
for approximately 40 minutes without being connected to the
power supply.
1. Switch off the device with the on/off switch 3 if necessary.
2. Connect the power unit 6 to the connector 5 of the device.
3. Insert the power unit 6 into a readily accessible wall socket
whose voltage matches the voltage stated on the rating
plate.
4. The LED 2 is lit red and the battery is charged. When the
battery is fully charged, the LED 2 is lit green. When the bat-
tery is fully charged, the device can be used for approxi-
mately 40 minutes without being connected to the power
supply.
85
GB