Before Starting; Charging The Battery - IKRA Mogatec IGBS 3.6 USB Manuel D'utilisation

Before starting

Items supplied
• Open the packaging and take out the equipment
with care.
• Remove the packaging material and any packaging
and/or transportation braces (if available).
• Check to see if all items are supplied.
• Inspect the equipment and accessories for transport
damage.
• If possible, please keep the packaging until the end of
the guarantee period.
Important! The equipment and packaging material are
not toys. Do not let children play with plastic bags, foils
or small parts.
There is a danger of swallowing or suffocating !

Charging the battery

Safety Instructions:
- When the hedge shears are delivered, the replacea-
ble battery is not charge. Before starting the machine
for the first time, the battery must be charged
- Use the included charging unit for charging the bat-
tery only. It is specially designed to match the tool's
battery.
- Connect the battery charger only to mains with such a
voltage as stated on the type-bearing plate.
- Never use other charging unit. This will result in fire
and/or explosion hazard!
- Always keep the charging unit clear of rain or mois-
ture. Hazard of electric shock! - Never charge the
battery in the open without protection, always choose
a dry, protected place.
- Never try to charge third-party batteries with this
charging unit. This will result in fire and/or explosion
hazard!
- Check the housing, plug and cable for damage before
each use of the charging unit. Do not use the unit if
you detect damage.
- Do not open the charging unit by force. In case of a
defect, the charging unit must be replaced.
- The charging unit heats up during the charging pro-
cess. Do not place the unit on a flammable surface or
operate it in a flammable environment. Fire hazard!
- Never open the battery cells. Hazard of short circuits!
- In case of damage to the battery, hazardous vapours
or fluids may escape. In case of incidental contact
flush with water and seek medical advice immedi-
ately. The fluid may have irritating or caustic effects
on the skin.
- Charge the batteries only at a temperature within the
range of 10°C to 40°C.
- Store the battery at temperatures up to 30°C only.
Higher storage temperatures may result in damage
to the battery. The ideal storage temperature range
is 10-15°C.
GB | Operating Instruction
- Protect the battery from heat, intense insolation and
- The battery is equipped with a deep-discharge pro-
- Before storing the batteries for the wintertime, charge
Charging the battery pack
• Connect the charger to the charging station (Fig. 2).
• Check that your mains voltage is the same as that
• Plug the battery charger in a socket-outlet. The red
• The battery pack is being charged. An empty battery
• As soon as battery pack is fully charged, the red
Timely recharging of the battery pack will help it serve
you well for a long time.
Recharging is always necessary when you notice a drop
in the tool's performance.
Never allow the battery pack to become fully discharged.
This will cause it to develop a defect.
Alternatively the device can also be charged via USB
cable on a computer or something similar.
Switching the tool on/off
Press the safety lock (3) and activate switch (4). After
the tool has been switched on, you do not have to hold
the switch-on lock (3) any longer.
To switch off just let go of the switch (4).
Hints for your work with the tool
Cutting grass
The area to be cut must first be cleared of stones and
other solid objects.
Allow the grass cutter to glide above the ground. The
best results are achieved when the lawn is dry.
When you notice a drop in cutting performance, re-
charge the tool immediately so that the battery does not
become fully discharged.
GB-7
fire. Explosion hazard!
tection feature: the tool is automatically switched off
if the battery is discharged. Recharge the battery
immediately if this should be the case.
them fully once more.
marked on the rating plate of the battery charger.
LED (Fig. 2 / Item A) comes on to indicate that charg-
ing voltage is available.
pack requires a maximum charging period of 1.5
hours. The temperature of the battery pack may rise
slightly during the charging operation. This is normal.
LED (Fig. 2/Item A) extinguishes. If the rechargeable
battery fails to charge, check whether there is voltage
at the socket outlet.
Attention! The blades will coast for a certain
time after switch-off!
As the device is operated with one hand
please be careful not to move the other hand
near the running cutting tools.
(Fig. 1)