Fire Safety - KIRAMI TUBE Notice D'emploi

All manuals and user guides at all-guides.com
EN
TUBE outside heater for aluminium hot tubs- Instruction manual Page 14/44

Fire safety

If the heater is located near buildings, for example
on the side of a terrace, the distance of the
chimney from any combustible materials must be
adequate. Remember to check the distance both
laterally and vertically so that there isn't any risk of
fire. Safe minimum distance, from the chimney's
upper end, laterally is three (3) meters. Shorter
distance laterally is adequate in other parts of the
chimney. If the chimney is closer to any
combustible materials you must use special
insulated chimney, which has to be purchased
separately.
When positioned close to the roof or when taken through it, the top end of the insulated
chimney must be at least one (1) meter above the surface of the roof. Ask your local fire
officer for more information.
Notice also the fire safety in front of the furnace. There shouldn't be any combustible
materials in front of the furnace. There should be an area, which is demonstrated in the
picture that should be made of incombustible material such as concrete, sand or metal.
Grates
For the TUBE heater, two cast iron grates and one L-shaped iron plate
will be delivered. Those are to be positioned on the tracks in the heater.
The order of the grates is shown on the right side. L-shaped iron plate
is to be installed bended edge upwards. It will deflect the air and also
prevent the firewood to drop out from the heater.
Chimney
You can use a Ø150mm outer diameter acid-proof chimney with this heater. The reduced
end of the chimney fits inside the heater. The chimney parts can be purchased separately in
three different lengths: 20 cm, 50 cm and 100 cm. There are also available adjustable
chimney corners and 100 cm long protective sleeves for the lower part of the chimney.
We recommend a chimney kit for the heater. This package includes 200 cm chimney +
100cm protective sleeve and a standard hat. There are also spark protective hats available
for the chimney.
If you have purchased a chimney kit with the heater. It is
supplied in a separate box and has four parts (see picture
right) and it has to be assembled.
Remove the protective film from the thermal protection and
place the assembled chimney to the chimney outlet of the
stove.
Be careful, the edges of the chimney are very sharp. Use
protective gloves!
Updated 10/2013