KIRAMI TUBE Notice D'emploi page 15

All manuals and user guides at all-guides.com
EN
TUBE outside heater for aluminium hot tubs- Instruction manual Page 15/44
Usage
Warning!
Never start the fire when the tub is empty or the water
level is insufficient! Heating a non full tub will destroy
the heater!
The tub must always be filled so that the water level is at
least 5 cm above the upper pipe of the heater (picture on
the right). Only then it is safe to start the fire.
Do not start emptying the tub until the fire in the heater
is completely out! Heating a non full tub will destroy the
heater!
The water in the tub must not be allowed to freeze during the winter.
Empty the tub or make sure that the water is heated adequately.
The heater cannot be connected with a circulation pump! It will not stand
the pressure, since it has been designed to use only gravitational free
circulation.
Before using the tub for the first time, we recommend to rinse the stove's water circulation
pipes carefully. Rinse the inside of the heater through upper pipes with water so that possible
garbage comes out of the heater. When filling the tub, make sure that the rubber hoses used
for connecting the stove do not leak. If necessary, tighten the hose clamps.
Do not overheat the water. We recommend a bathing temperature of no more than +37°C.
Empty the heater from ashes after every use. If the grates stay inside the ashes, it will
shorten the lifetime of the grates considerably.
Use only small and dry firewood for the heater. The use of big and moist wood will easily
double the heating time. Use of common alder is not recommended, since it causes more
soot and stickier soot than other firewood.
The use of the heater that is loaded from outside of the barrel is as easy as the use of any
other normal fireplace. We recommend the use of small firewood when starting the fire and
then gradually add bigger ones, if needed. While heating the water, it is advisable to keep
up a fare-sized fire in the heater so that the wood would burn properly and the
maximum output can be achieved. When keeping a small fire the heating time will be
much longer.
When using lighter fluid act according to the instructions of the fluid. Never use any other
fluids than those that are made for it. We recommend the use of burning pieces, for example
Burner- paraffin bags.
Cleaning and chemicals
Take care of the sanitation and hygiene of the barrel by washing and drying it often enough.
You can wash the barrel with pine soap and scrubbing brush, or using some other bio soap.
Updated 10/2013