Fire Safety - KIRAMI CULT 22 Notice D'emploi

© Kirami Oy, Finland
Installation for plastic tubs (Easy / Family)
Heater for plastic tubs is connected with rubber hoses to the Ø75mm PVC pipes on the
tub. In this installation the heater is placed on the same level with the tub so both are
Chimney
You can use a Ø120mm outer diameter acid proof steel chimneys in this heater. The
reduced end of the chimney will fit inside the heater. These chimneys are sold in 50 and
100cm pieces. There is also a heat protection piece available
length of 100cm. We recommend a chimney kit that has
150cm chimney + 100cm heat protection + hat. There are also
hats with spark protection net available.
If you have purchased a chimney kit with the heater. It is
supplied in a separate box and has four parts (see picture
right) and it has to be assembled.
Remove the protective film from the thermal protection and
place the assembled chimney to the chimney outlet of the stove.
Be careful, the edges of the chimney are very sharp. Use protective gloves!

Fire safety

If the heater is located near buildings, for example on the side of a terrace, the distance of
the chimney from any combustible materials must be adequate. Remember to check the
distance both laterally and vertically so that there isn't any risk of fire. Safe minimum
distance, from the chimney's upper end, laterally
is three (3) meters. Shorter distance laterally is
adequate in other parts of the chimney. If the
chimney is closer to any combustible materials
you must use special insulated chimney, which
has to be purchased separately.
When positioned close to the roof or when taken
through it, the top end of the insulated chimney
must be at least one (1) meter above the surface
of the roof. Ask your local fire officer for more
information.
Notice also the fire safety in front of the furnace. There shouldn't be any flammable
materials in front of the furnace. There should be an area, which is demonstrated in the
picture that should be made of incombustible material such as concrete, sand or metal.
Instrcution manual: Kirami Cult outside heater for hot tubs
17/ 4 8
directly in contact with ground. And the heater is not
hanging in the air. On some plastic tubs this means that
you have to add some support
under the heater e.g. concrete
slabs or bricks. In the left
picture plastic tub connection
pipes. On the right side you see
an example of CULT connected
with plastic tub.
22.08 .2018
Page 3