EUROM Ceiling Fan 48 Manuel D'utilisation page 13

Ceiling fan
Your ceiling fan should be installed by someone with an understanding of electrical
cabling.
• Disconnect the power.
• Remove the packaging materials.
• De not remove the 3 cardboard discs on the motor
housing, the provide stability.
• Screw the three turbines to the motor casing
securely with 2 nuts and rings each; the connection
bracket should face the ceiling (see diagram).
• Secure the plate with the suspension hook to the
ceiling, directly next to the electrical connection
point.
Decide which screws (and plugs or bolts) are
-
required for your base material. The materials
which are enclosed are suitable for wood. If you
have another base and you are not sure, ask for
advice regarding which materials are required!
Mark the right location for the screws. If
-
necessary, drill holes and use plugs/key bolts.
Screw the plate (suspension hook downwards)
-
into place securely. Use a flat ring and a spring
washer between the screw and plate for extra
rigidity. Make sure no wires are trapped between
the ceiling and the plate!
• Slide the upper protective cap on the fan downwards and hang the fan on the
suspension hook using the pulley. Make sure that no wires become trapped
between hook and pulley!
Check to make sure that everything is secure.
• Connect the wires from the connection point to the corresponding wires in the
connector: Brown = L (phase), Blue = N (neutral), green/yellow = earth
Important! Do not switch any wires; this will damage the device!
13
.