EUROM Ceiling Fan 48 Manuel D'utilisation page 12

Diagram of components
1. motor housing
2. fan turbine
3. connection bracket
Description
The Ceiling Fan 48 is intended to provide a refreshing flow of air in the relevant room.
It has been designed to be connected to an electrical point in the ceiling. It is operated
using a special, wall-mounted operating unit that is connected to the connection point
in the ceiling.
This wall-mounted contact unit enables the fan to be set to 3 different settings (LOW
– MED - HI) and switched off (OFF).
Installation
Electrical installation
Before beginning to install the fan and/or the operating unit, the electrical installation
must be adequately prepared.
Choose the location on the ceiling where you would like to hang the fan. At this
location, there must be an electrical connection point (220-240V~50HZ) with the
correct cabling that is connected to the wall-mounted unit in order to operate the fan.
This connection point must only be installed by an approved electrician. The ceiling
must also be:
At least 266 cm above the floor.
-
Made of material that is suitable and sturdy enough to bear the fan (also during
-
use), i.e. concrete, wooden beams or similar but not plaster, soft boards, scrap
etc. able to bear at least 100 kg.
4. upper protective cap
5. operating unit
12