Combustion Air Inlet - Butler HL 90 Notice De Montage

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

HL90 EA_de_en_fr.book Seite 28 Freitag, 8. Oktober 2004 12:34 12
Statutory regulations governing installation

2.5. Combustion air inlet

2.5.1. The air for the combustion chamber of the heater must not be
extracted from the passenger cabin of the vehicle.
2.5.2. The air inlet must be positioned in such a way that it cannot be
obstructed by other objects.
2.6. Hot air inlet
2.6.1. The supply of heating air must consist of either fresh air or
recirculated air and must be taken from a clean area which cannot be
contaminated by exhaust fumes from the engine, the internal
combustion heater or any other source in the vehicle.
2.6.2. The inlet line must be protected by a grating or other suitable
means.
2.7. Hot air outlet
2.7.1. Hot air lines within the vehicle must be positioned or protected in
such a way as to exclude all risk of injury or damage caused by direct
contact.
2.7.2. The air outlet must be positioned or protected so that it cannot be
obstructed by other objects.
2.8. Automatic control of the heating system
When the engine stops, the heating system must cut out automatically
and the fuel supply must be stopped within 5 seconds.
The heating system may remain in operation if a manual unit has
already been activated.
28
All manuals and user guides at all-guides.com
Visit www.butlertechnik.com for more technical information and downloads.
www.butlertechnik.com
IMPORTANT:
Failure to follow the installation instructions and the notes contained
therein will lead to all liability being refused by Webasto. The same
applies if repairs are carried out incorrectly or with the use of parts other
than genuine spare parts. This will result in the invalidation of the type
approval for the heater and therefore of its homologation / EC type
licence.
HL 90

Publicité

Table des Matières
loading

Table des Matières