Fein ABS14 Mode D'emploi page 15

OBJ_BUCH-0000000113-002.book Page 15 Wednesday, June 25, 2014 8:31 AM
Selecting the rotation direction
(figure 5).
To avoid accidental starting, e. g., during
transport, set the rotation selector switch to
the centre position.
Set the rotation selector switch to right or left
rotation as required.
Adjust the rotation selector switch only
when the machine is at a complete stop.
Setting the operating mode.
Change the operating mode only when the
power tool is switched off! Otherwise, the
machine can become damaged.
Always turn the operating mode selector
switch to the stop. Otherwise, the machine
can become damaged.
ASB 14/18 (figure 6)
Set the desired operating mode.
– For drilling, set the operating mode selec-
tor switch to the "drilling" symbol.
– For screwdriving, set the operating mode
selector switch to the "'screwdriving'"
symbol.
– For hammer drilling, set the operating
mode selector switch to the "hammer
drilling" symbol.
ABS 14/18 (figure 7)
Set the desired operating mode.
– For drilling, adjust the torque setting to the
"drilling" symbol.
Fig. 5
Rotational direction switch
Fig. 6 Operating mode selector switch
Fig. 7
Torque setting
en
15