Fein ABS14 Mode D'emploi page 14

OBJ_BUCH-0000000113-002.book Page 14 Wednesday, June 25, 2014 8:31 AM
en
14
Working instructions.
Before mounting or replacing application tools or accessories, remove the bat-
WARNING
tery. This preventive safety measure rules out the danger of injuries through
accidental starting of the power tool.
Do not use accessories not specifically intended and recommended for this power tool by FEIN.
The use of non-original FEIN accessories can lead to overheating of the power tool and destroy
it.
For each job, use only the FEIN application tool released and intended for the
CAUTION
respective application.
Setting the torque (figure 4).
The factory setting is for the small to mid-size
screw range.
The tightening torque also depends on the
force with which the power tool is pressed
against the screw.
– Low torque: Small screws
– High torque: Large screws
Determine the torque setting with which the
screws are screwed flush into the material by
practical testing.
Fig. 4
16
14
12
10
8
6
4
2
Torque setting
24
22
20
18