Din En 13463-1 Din En 13463 - Simalfa Primus Instructions De Service

Table of contents
Exploded Drawing
Declaration of CE-Conformity
Replacement parts
1 General
1.1 Model identification
1.2 Intended use
1.3 Inappropriate use
2 Technical description
3 Safety instructions
3.1 Identification of safety instructions
3.2 General Safety instructions
4 Assembly
4.1 Supply line connection
5 Operation
5.1 Start-up and shut-down
6 Spray pattern adjustments
6.1 Correcting spray pattern flaws
7 Troubleshooting and fault rectification
8 Conversion and repair
9 Cleaning and maintenance
9.1 Basic cleaning
10 Disposal
11 Technical data
All manuals and user guides at all-guides.com
6
21
22
24
24
24
24
25
25
25
25
26
26
28
28
28
29
30
30
31
31
32
33
20
Declaration of EC/EU-Conformity
We, the manufacturers of the equipment, hereby declare under our sole responsibility that
the product(s) described below conform to the essential safety requirements. This declaration will
be rendered invalid if any changes are made to the equipment without prior consultation with us.
Manufacturer ALFA Klebstoffe AG
Vor Eiche 10
CH-8197 Rafz, Switzerland
Tel. +41(0) 43 433 30 30
Fax +41(0) 43 433 30 33
Email: switzerland@simalfa.com
www.simalfa.ch • www.alfa-klebstoffe.com
Alfa Adhesives, Inc.
15 Lincoln Street
Hawthorne, NJ 07506 USA
Telephone: 1 973.423.9266
Fax: 1 973.423.9264
Email: usa@simalfa.com • www.simalfa.com
Type Designation Hand-held Spray Gun SIMALFA Primus
Material connection upper
Material connection lower
Intended purpose Processing of sprayable media
Applied Standards and Directives
EU-Mechanical Engineering Directives 2006/42/EC
2014/34/EU (ATEX Directives)
DIN EN ISO 12100
DIN EN 1953
DIN EN 1127-1
Specification according 2014/34/EU
Category 2 Part marking
Authorized with the compilation of the technical file:
Thomas Simmler, ALFA Klebstoffe, Vor Eiche 10
CH-8197 Rafz, Switzerland
Special remarks :
The named product is intended for installation in other equipment. Commissioning is prohibited
until such time as the end product has been proved to conform to the provision of the Directives
2006/42/EC.
Rafz, the 2nd of November 2016
i.V.
Name: Thomas Simmler
Position: Executive Director
This Declaration does not give assurance of properties in the sense of product liability. The safety instructions
provided in the product documentation must be observed at all times.
V 10 707
V 10 708
DIN EN 13463-1
DIN EN 13463-5
II 2 G c T 6
21