Changing The Saw-Blade; Maintenace And Cleaning; Dust Extraction - ADEO Services HF-CS185TS Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1

Changing the saw-blade

Disconnect the tool from the power-supply and wear working-gloves, in order to
avoid injuries!
Place both hooks of the spanner into the holes of the outer flange and place the
ring-spanner onto the fixing-screw (11) at the same time.
Loosen the fixing-screw (11) by turning the ring-spanner in anti-clockwise direc-tion.
Remove the fixing-screw and the outer flange, open the blade-cover and take out the
saw-blade.
For mounting the new saw-blade follow these instructions in opposite order. The teeth of
the saw-blades must show in the direction of rotation, which is shown by an arrow on the
machine-housing.
10、MAINTENACE AND CLEANING
Your circular saw does not require any special maintenance.
Be sure to disconnect the circular-saw from the power-supply, before cleaning.
Clean the machine from chips and dust after each use by using a dry cloth or brush.
Do not use any detergents, as they might affect the housing.
Put a drop of machine-oil to the thread of the fixing-screw of the saw-blade,
when changing the blade.
If the carbon brushes need to be replaced, have this done by a qualified repair person
(always replace the two brushes at the same time).
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a hazard
From time to time, clean dust on the protection system with a dry brush. Clean the
housing only with a damp cloth, do not use any solvents! Dry thoroughly afterwards

Dust extraction

The chip ejector (14) of the circular-saw is prepared for fixing a vacuum cleaner. It is
recommended to always connect a vacuum cleaner, when using the circular-saw.
11、ENVIRONMENT
Should your machine need replacement after extended use, do not put it in the domestic
waste but dispose of it in an environmentally safe way. Waste electrical products should not
be disposed of with household waste. Please recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice
CAUTION! This product has been marked with a symbol relating to removing electric
and electronic waste. This means that this product shall not be discarded with
145

Publicité

Table des Matières
loading

Produits Connexes pour ADEO Services HF-CS185TS

Table des Matières