Technical Specification - ADEO Services HF-CS185TS Mode D'emploi

5、Fixing screw for cutting angle
6、Saw plate
7、Marking for bevelled cuts 45°
8、Marking for straight cuts
9、Fixing screw for parallel guide
10、Parallel guide
11、Fixing screw for saw blade
12、Riving knife
13、Blade cover
14、Chip ejector
15、Fixing screw for cutting depth
8、TECHNICAL SPECIFICATION
voltage
Rated power
No-load speed
Max. Cutting depth at 90°
Max. Cutting depth at 45°
Saw blade

Sound pressure level(L
Sound power level(L
Vibration emission value: K=1.5 m/s²
Main Handle
Auxiliary handle
- that the declared vibration total value has been measured in accordance with
a standard test method and may be used for comparing one tool with another
- that the declared vibration total value may also be used in a preliminary
assessment of exposure
A warming:
- that the vibration emission during actual use of the power tool can differ from
the declared depending on the ways in which the tool is used
To reduce vibration risk
-wear anti-vibration gloves
-shorten trigger time
Warning!
ear-protection during operation!
9、USING THE CIRCULAR SAW
230-240V~50HZ
1200W
5000/min
63mm
38mm
185mm
99,5dB(A); K=3 dB(A)
)
pa
110.6 dB(A);K=3 dB(A)
)
wa
3.26 m/s²
3.5 m/s²
Be sure to wear and safety goggles, dust-mask and
143