Adjusting The Cutting-Depth; Parallel Guide; Adjusting The Cutting Angle - ADEO Services HF-CS185TS Mode D'emploi

Insert mains plug into an outlet, always check that the power supply corresponds

to the voltage on the rating plate (Rated voltage: 230-240V~50HZ).
Be sure, that all screws, nails or other metal-parts are removed from the

workpiece, before starting your work.
 Always fix the workpiece by using clamps with that side down, which will be
visible later, since this side will be cut particularly smooth.
 For safey reason the safety guard must automatically cover the blade while the
tool lift in the air.
For safety reasons the circular saw is equipped with a switch-lock (2). Before

switching on, the lock has to be pressed. When the switch (1) is released, the
circular-saw is switched off.
Switch ON the circular saw, before the saw-blade touches the workpiece.

 Do not start cutting, before the tool has reached its maximum speed.
 Lead the machine without too much pressure and let the saw-bladecut smoothly.
Do not brake the saw-blade by pressing from either side, after the machine is

switched off.
Be sure the circular saw is switched off and the saw blade has come to a

complete stop, before you lay down on the desk or workbench.
Wiping on blade lubricating oil to avoid some workpiece damaged caused by the

overheating of blade while working.

Adjusting the cutting-depth

 For adjusting the cutting-depth loosen the fixing-screw (15).
Adjust the required cutting-depth and fasten fixing-screw (15) again.

The scale on the backside of the housing will help you adjusting the cutting-depth

correctly.
 To achieve an optimum cut, the saw blade must not protrude more than 5 mm at
the most from the workpiece.

Parallel guide

The parallel guide (10) enables exact cuts along an edge of the workpiece.
 Loosen the screw (9) and adjust the required distance.
Fasten screw (9) again.

The cutting mark (8) indicates the position of the saw blade for right angle

cuts. The cutting mark (7) indicates the position of the saw blade for 45°
cuts.

Adjusting the cutting angle

The cutting angle can be adjusted between 0° and 45°.
 Loosen the winged screws (5), adjust the cutting angle by tilting the base-plate (6)
downwards, until the required cutting angle is adjusted on the cutting angle scale.
Tighten the winged screws (5) again.

144