ADEO Services HF-CS185TS Mode D'emploi page 138

rate for which it was designed.
b) Do not use the power tool if the switch does not turn it on and off.
Any power tool that cannot be controlled with the switch is dangerous
and must be repaired.
c) Disconnect the plug from the power source and/or remove the
battery pack, if detachable from the power tool before making
any adjustments, changing accessories, or storing power tools.
Such preventive safety measures reduce the risk of starting the power
tool accidentally.
d) Store idle power tools out of the reach of children and do not
allow persons unfamiliar with the power tool or these
instructions to operate the power tool. Power tools are dangerous
in the hands of untrained users.
e) Maintain power tools and accessories. Check for misalignment
or binding of moving parts,breakage of parts and any other
condition that may affect the power tool's operation. If damaged,
have the power tool repaired before use. Many accidents are
caused by poorly
maintained power tools.
f) Keep cutting tools sharp and clean. Properly maintained cutting
tools with sharp cutting edges are less likely to bind and are easier to
control.
g) Use the power tool, accessories and tool bits etc. in accordance
with these instructions, taking into account the working
conditions and the work to be performed. Use of the power tool for
operations different from those intended could result in a hazardous
situation.
h) Keep handles and grasping surfaces dry, clean and free from oil
and grease. Slippery handles and grasping surfaces do not allow for
safe handling and control of the tool in unexpected situations.
5) Service
a) Have your power tool serviced by a qualified repair person using
only identical replacement parts. This will ensure that the safety of
the power tool is maintained.
3、SAFETY INSTRUCTIONS FOR SAW
Cutting procedures
DANDER : Keep hands away from cutting area and the blade.
a )
Keep your second hand on auxiliary handle, or motor housing. If both
hands are holding the saw, they cannot be cut the blade.
b ) Do not reach underneath the workpiece. The guard cannot protect
138