Troubleshooting; Beware Of Condensation - Teac SL-D900 Manuel Du Propriétaire

If you have problems with your system, look through this
chart and see if you can solve the problem yourself
before calling your dealer or TEAC service center.
General
No power
e Check the connection to the AC power supply.
Check and make sure the AC source is not a
switched outlet and that, if it is, the switch is turned
on. Make sure there is power to the AC outlet by
plugging another item such as a lamp or fan into
the outlet.
No sound from speakers.
e Select the source by pressing the FUNCTION button.
e Adjust the volume.
e Pull out the headphone's plug from the PHONES
jack.
eIf the VOLUME level indicator is blinking, press the
MUTING button. (When "CD" or "CARD-USB" is
selected, press the Play/Pause button (G/J) to start
playback.)
The sound is noisy.
e The unit is too close to a TV or similar appliances.
Install the unit apart from them, or turn them off.
Remote control doesn't work.
e Press the STANDBY/ON switch to turn the unit on.
e When the battery has run out, put in a new one.
e Use remote control unit within the range (5 m) and
point at the front panel.
e Clear obstacles between the remote control unit
and the main unit.
e If a strong light is near the unit, turn it off.
CD Player
Cannot play.
e Load a disc with the label side up.
e If the disc is dirty, clean the surface of the disc.
e A blank disc has been loaded. Load a prerecorded
disc.
e Depending on the disc, etc. it may not be possible
to play back CD-R/RW discs. Try again with another
disc.
e You cannot play back unfinalized CD-R/RW discs.
Finalize such a disc in a CD recorder and try again.
26
All manuals and user guides at all-guides.com

Troubleshooting

Sound skips.
e Place the unit on a stable place to avoid vibration
and shock.
e If the disc is dirty, clean the surface of the disc.
e Don't use scratched, damaged or warped discs.
Tuner
Cannot listen to any station, or signal is too weak.
e Tune in the station properly.
e Rotate the unit or antenna for the best reception
position.
Though the broadcast is stereo, it sounds
monaural.
e Press the FM MODE button.
If normal operation cannot be recovered, unplug
the power cord from the outlet and plug it again.
If the power supply is interrupted, the settings
kept in memory (clock, preset stations, timer
setting) will be erased.

Beware of condensation

When the unit (or a disc) is moved from a cold to a
warm place, or used after a sudden temperature
change, there is a danger of condensation; vapor in
the air could condense on the internal mechanism,
making correct operation erratic or impossible. To
prevent this, or if this occurs, leave the unit for one or
two hours with the power turned on. The unit will
stabilize at the temperature of its surroundings.
Maintenance
If the surface of the unit gets dirty, wipe with a soft
cloth or use diluted mild liquid soap. Never spray
liquid directly on this unit. Apply your cleaner to your
cleaning cloth and wipe gently. Be sure to remove
any excess completely. Do not use thinner, benzene
or alcohol as they may damage the surface of the
unit. Allow the surface of the unit to dry completely
before using.