Pioneer HTP-700 Mode D'emploi page 79

Additional information
Problem
Considerable noise in radio
broadcasts.
Broadcast stations cannot
be selected automatically.
Noise during playback of a
cassette deck.
Sound is produced from
other components, but not
from LD or DVD player.
No sound is output or a
noise is output when
software with DTS is played
back.
During a playback search,
noise is output from a DTS
compatible CD player.
Everything seems to be set
up correctly, but the
playback sound is odd.
There seems to be a time lag
between the speakers and
the output of the subwoofer.
Can't operate the remote
control.
The display is dark or off.
All manuals and user guides at all-guides.com
Remedy
• Connect the antenna (page 36) and adjust the position for best reception.
• Route any loose cables away from the antenna terminals and wires.
• Fully extend the FM wire antenna, position for best reception, and
secure to a wall (or connect an outdoor FM antenna).
• Turn off equipment causing interference or move it away from the
system (or move antennas farther away from equipment causing noise).
• Connect an outdoor antenna (refer to page 36).
• Move the cassette deck away from your system, until the noise
disappears.
• Set the SIGNAL SEL to HDMI, C1/O1/O2 (DIGITAL) or A (analog)
according to the type of connections made (refer to page 48).
• Set the digital input settings correctly (refer to page 48).
• Make digital connections (refer to page 27) and set the SIGNAL SEL to
C1/O1/O2 (DIGITAL) (refer to page 48).
• Refer to the instruction manual supplied with the DVD player.
• Set the digital volume level of the player to full, or to the neutral position.
• Make sure the player's settings are correct and/or the DTS signal out is
on. Refer to the instruction manual supplied with the DVD player.
• Set the input signal type to C1/O1/O2 (DIGITAL) (see Choosing the
input signal on page 48).
• This is not a malfunction, but be sure to turn the volume down to
prevent the output of loud noise from your speakers.
• Check that the positive/negative speaker terminals on the system are
matched with the corresponding terminals on the speakers (see page 14,
18 or 22).
• See Automatically setting up for surround sound (MCACC) on page 45 to
set up your system again using MCACC (this will automatically
compensate for a delay in the subwoofer output).
• Replace the batteries (refer to page 44).
• Operate within 7 m, 30° of the remote sensor (refer to page 44).
• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
• Press DIMMER on the control repeatedly to return to the default.
10
79
En