Choosing The Input Signal - Pioneer HTP-700 Mode D'emploi

04 Getting started

Choosing the input signal

On this system, it is possible to switch the
input signals for the different inputs as
1
described below.
SYSTEM
1 Press
2 Press SIGNAL SEL to select the input
signal corresponding to the source
component.
When DIGITAL (C1/O1/O2) or HDMI (H) is
selected and the selected audio input is not
provided, A (analog) is automatically selected.
Each press cycles through the following:
• A – Selects the analog inputs.
• DIGITAL – Selects the digital input. The
coaxial 1 input is selected for C1, and the
optical 1 or 2 audio input is selected for
O1 or O2.
• HDMI – Selects an HDMI signal. H can be
selected for BD/DVD, TV/SAT or DVR/VCR
input. For other inputs, HDMI cannot be
2
selected.
When set to DIGITAL or HDMI, 2 lights when
a Dolby Digital signal is input, and DTS lights
when a DTS signal is input.
When the HDMI is selected, the A and
DIGITAL indicators are off (see page 38).
Note
1 • This system can only play back Dolby Digital, PCM (32 kHz to 96 kHz) and DTS (including DTS 96 kHz / 24 bit) digital
signal formats. The compatible signals via the HDMI terminals are: Dolby Digital, DTS, SACD (DSD 2 ch), PCM (32
kHz to 192 kHz sampling frequencies), Dolby TrueHD, Dolby Digital Plus, DTS-EXPRESS, DTS-HD Master Audio and
DVD Audio (including 192 kHz). With other digital signal formats, set to A (analog) (TUNER).
• You may get digital noise when a LD or CD player compatible with DTS is playing an analog signal. To prevent noise,
make the proper digital connections (page 27) and set the signal input to C1/O1/O2 (DIGITAL).
• Some DVD players don't output DTS signals. For more details, refer to the instruction manual supplied with your
DVD player.
2 When the HDMI option in Setting the Audio options on page 63 is set to THRU, the sound will be heard through your
TV, not from this system.
48
En
All manuals and user guides at all-guides.com
TV CONTROL
INPUT
CH
VOL
DIMMER SIGNAL SEL
BD MENU
on the remote control.