Pioneer HTP-700 Mode D'emploi page 64

07 Listening to your system
Setting
d
DUAL MONO
DRC
(Dynamic Range
Control)
LFE ATT
(LFE Attenuate)
HDMI
(HDMI Audio)
A.DLY
(Auto Delay)
The following settings are not supported by the HTP-FS500.
g
C.WIDTH
(Center Width)
(Applicable only
when using a center
speaker)
g
DIMEN.
(Dimension)
64
En
All manuals and user guides at all-guides.com
What it does
Specifies how dual mono encoded Dolby Digital
soundtracks should be played.
Adjusts the level of dynamic range for movie
soundtracks optimized for Dolby Digital, DTS, Dolby
Digital Plus, Dolby TrueHD, DTS-HD and DTS Master
Audio (you may need to use this feature when
listening to surround sound at low volumes).
Some Dolby Digital and DTS audio sources include
ultra-low bass tones. Set the LFE attenuator as
necessary to prevent the ultra-low bass tones from
distorting the sound from the speakers.
The LFE is not limited when set to 0 dB, which is the
recommended value. When set to –10 dB, the LFE is
limited by the respective degree. When OFF is
selected, no sound is output from the LFE channel.
Specifies the routing of the HDMI audio signal out of
this system (amp) or through to a TV or flat screen TV.
When THRU is selected, no sound is output from this
system.
This feature automatically corrects the audio-to-video
delay between components connected with an HDMI
cable. The audio delay time is set depending on the
operational status of the display connected with an
HDMI cable. The video delay time is automatically
adjusted according to the audio delay time.
Spreads the center channel between the front right
and left speakers, making it sound wider (higher
settings) or narrower (lower settings).
Adjusts the surround sound balance from front to
back, making the sound more distant (minus
settings), or more forward (positive settings).
Option(s)
CH1 –
Channel 1 is heard only
CH2 –
Channel 2 is heard only
CH1 CH2 –
Both channels heard
from front speakers
e
AUTO
MAX
MID
OFF
LFEATT 0 (0 dB)
LFEATT 10 (–10 dB)/
LFEATT ** (OFF)
AMP
THRU
OFF
ON
f
0 to 7
Default: 3
–3 to +3
Default: 0